Mini-VNA PRO BT Antenna analyser with Bluetooth

The mini-VNA Pro BT is a furthr development of the worldwide highly acclaimed mini-VNA Network Analyser. The most prominent enhancements are a built in LiIon battery and the new Bluetooth interface. Both enhancements allow you to use the mini-VNA Pro BT ouitdoors, directly at the base of the antenna.

Further functions and technical data of the mini-VNA Pro BT

* Frequecy range 0.1 to 200MHz
* Calibration using open/short-load for accurate results
* Range of impedance Z from 1 to 1000?
* Two ports VNA with S11 and S12 display; displayed and save results
* I/Q DDS Generator with 0 dBm output power
* Two separate RF outputs for I/Q for SDR experiemnts and IMD measurements with independant attenuator from 0 to 55dB, phase angle adjustable to 1° precision
* Built in Bluetooth® Adaptor (Class 1) for wireless remote measurements
* Built in LiIon 1000mAh battery, (4 hours full-scan operation)
* Built in battery charger (up to 400mA)
* Accessory port for future optional interfaces and frequency extenders
* Low power consumption, 220mA @3.6V, (analyser mode using USB port)
* Power save mode
* SMA connectors for better isolation
* extended dynamic range: up to 90dB for transmission, up to 50dB for reflection
* Boot loader for future firmware upgrades
* User friendly interface for PC Windows, Linux and MAC
* Integrated Smith Chart in software
* Measurements of motional crystal parameters, cable lengths & more
* Export dat in several formats: JPG, Excel, ZPLOT, S2P, PDF

Included in shipment is:

* Mini VNA Pro BT incl. Akku
* CD-ROM with drivers and software
* USB cable
* Three part calibration kit SMA (50? Terminator, short, open)

Price: About 390 EU

This entry was posted in ham, new equipment and tagged , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *