Icom IC-7300 HF/50 MHz Transceiver – wide band modification.
1. Check the radio to be disconnected from power supply
2. Please, use ESD discharge measures! No kidding, use ESD countermeasures both for your body and for the soldering station!
3. Use a lot of soldering flux! The diodes are very sensitive to high temperature and the solder Flux (I use GEL type) help in reducing the temperature for the areas not touched by the soldering station’s tip.
4. Use 60/40 soldering alloy to reduce the melting point for the ROHS solders!
5. Use unsolder braid to clean the PCB pads!
6. Use a good soldering station!
7. Use good tweezers.
8. Use good magnifing glasses AND/OR microscope. The diodes are very very small.
Note:
Open RX 0.030-74.8Mhz (REMOVE D416)
Open TX 0.1-74.8Mhz (REMOVE D422) (D419 is and must be in)
** Only Open TX 60Mtr 5.255-5.405Mhz (REMOVE D405)
Video by YO3HJV
Same thing here. Doing tis mod absolutely removes any 6m capability, and there is no way to get it back that I know of. Sure wish ANYONE would’ve informed me of this beforehand!
Did wide band converson, works great up through 29.999, will not go above this
frequency. I did a full reset still will not work on 6 meters. Any suggestions.