With CFE unit, signals are being listening through multiple narrow crystal filter directly on antenna. This amzingly decrease S/N ratio of your receiver, and improve IMD resistance incrediably.
CFE can be used with any transciever. Thanks to CAT control, CFE is connected on your radio and crystal filters will be swithched automaticaly.
On large LCD display you can easily see your frequency “position” inside filter curennly in use, and all other needed information.
You can have two of these units work in network, on the same band, what make incrediable isolation of two receiver on close frequencies. It make SO, Single Band Two radio operating much more comfortable.
Crystal filters are ordered by user. It make any configuration possible. You can choose number, bandwidth, and can make CFE to reach your needs.
Of course, more narrow filters, better perfomances are, but less band is covered and price is higher.
ACS ( Advanced Contest Solution ) give you opportunity to chose band segments and you can even have fifferent bands segments installed in same unit. For example, 5x1kHz on 160M, 5x1kHz on 40M and 5x1kHz on 20M…Or whatever.
Unit is USB controlled and you can upgrade firmware, make settings if change, or install new filter.
Icom IC-PW2 1kW HF+ 6m Amplifier
On August 31, 2019, Icom Co., Ltd. announced the IC-PW2 - 1kW linear amplifier in the HF + 50MHz band at its booth at Ham Fair 2019. Full power, full duty specification that uses LDMOS for the final...
HF/VHF/UHF SDR ICOM “IC-705” Transceiver A new HF +50/144/430 Mhz transceiver will be shown and announced on "HAM FAIR 2019" on August 31st (Sat) and 1st (Sun) September 2019 in Tokyo. ICOM "IC-705" 10 Watts of power with new SDR technology.
PTRX-7300 Panorama Adaptor for the IC-7300
A panorama adapter for the IC-7300? What's the point, you might ask, the IC-7300 has such a nice spectrum and waterfall display? Right, but unfortunately the IC-7300 has no output for an external display....