The MFJ-929 IntelliTuner-CompactЩ lets you automatically tune any coax fed or random wire antenna 1.8 – 30 MHz at full 200 Watts SSB/CW. It can match 6-1600 Ohms (SWR up to 32:1) – thats a 50% wider matching range at a higher power level than lesser competing products.
You get a digital SWR/Wattmeter with backlit LCD, antenna switch for 2 antennas, built-in radio interface and built-in internal BiasTee for remote tuner operation.
MFJs exclusive IntelliTuneЩ, Adaptive SearchЩ and InstantRecallЩ algorithms give you ultra-fast automatic tuning with over 20,000 VirtualAntennaЩ Memories.
MFJ VirtualAntennaЩ Memory
MFJ new VirtualAntennaЩ Memory system gives you 4 antenna memory banks for each of 2 antenna connectors. You can select up to 4 antennas on each antenna connector. Each antenna has 2500 memories.
4 Times the Solutions!
MFJ-929 gives you 256 values each of capacitance and inductances for 131,072 matching solutions. Thats 4 times the 32,768 matching solutions of competing products with only 128 L/C values each!
Highly intelligent, ultra-fast tuning!
Don’t be fooled by competing products claiming fast search times — if you have a quarter of the matching solutions, of course, it takes less time to finish but its not faster.
MFJ’s faster speed comes from advanced technology and software algorithms not from fewer matching solutions.
MFJ’s IntelliTuner-CompactЩ actually measures complex impedance — R and X –of your antenna, computes the L-network values needed and snaps in those components to give you an instant match.
If the load is out of measurement range, AdaptiveSearchЩ determines the smaller sub-set from all solutions that can match a safe load — and then searches only that subset — others search through far more solutions.
Digital LCD SWR/Wattmeter
An easy-to-read, two-line, 16-character backlit LCD displays SWR, peak or average forward/reflected power, frequency, antenna 1 or 2, L/C tuner values, on/off indicators and other info. They are selected from easy-to-understand menus; not complex combinations of buttons you can’t remember.
A fast-response, high-resolution bargraph gives you an auto-ranging 20/200 Watt power meter. You get 60 segments each for forward and reflected power and 36 segments for SWR — try that with an 8 segment bargraph that makes you change power ranges and doesn?втВмтДвt even give you reflected power!
You can read inductance and capacitance directly in uHy and pF. This turns you into an expert L-network designer! Match your load, read the resulting L/C values, then use them to build your fixed L-network.
Or, knowing the L/C values you can determine R and X of the load impedance.
StickyTuneЩ mode gives you one-hand tuning by locking the TUNE button; just transmit to tune regardless of SWR.
Has audio SWR meter and audio feed back. Competing products don’t. Built-in 50 MHz frequency counter. Its built-in radio interface lets you use a simple wire cable to compatible rigs. Others require a cable with expensive electronics. Binding post for random wire. Self-test. Highly efficient L-network. 10 Amp/1000V relays, RF duty silver mica capacitors.
6 ?” x 2 ?” x 7 ?”. 2.4 lbs. 12-15 VDC/ 1 Amp or 110 VAC with MFJ-1316.
LAMCO DU-1500 1.5Kw Antenna Tuners New LAMCO DU-1500 1.5Kw Antenna Tuners.
LAMCO DU-1500 L 1.5Kw Antenna Tuner
LAMCO DU-1500 L manual roller coaster ATU 1500Watts hand built to perfection. Coaxial , balanced line and end fed wire. Internal...
Elecraft KAT500 High Power Autotuner (in May 2012)
Good news came from USA / Elecraft:
The KAT500 is a new high power autotuner that is can be used with both the K3/KPA500 and all other HF amplifiers and transceivers. The KAT500 uses the same topology...
Alinco EDX2 Fully Automatic Antenna Tuner Fully Automatic Antenna Tuner - Pre-wired for Alinco
Alinco EDX-2 ATU
HF Auto Tuner pre-wired for Alinco
120W power handling
Weatherproof case for outside installation