The PSE-508-2 is a full-featured, reliable, easy-to-install and set up repeater controller for the GE Mastr II series of repeaters.
Its features include:
Easy installation and setup: “Plug and Play” repeater control for the GE Mastr II.
Built-in CTCSS Tone Decoder with adjustable timeout.
Built-in CTCSS Tone Encoder with two modes: Encode on RUS (COR) only, or Encode on PTT.
CTCSS Encoder has user-selectable Reverse-Burst mode.
Voice and CW Repeater Identification.
Voice Announcement Mode (ID via CW): Record voice announcements and play back manually using the DTMF button and/or periodically based on a timer.
Precision computer-aided-designed filters and audio amps, with just the right de-emphasis profile, provide exceptionally crisp and clear audio.
All critical components are qualified for the industrial temperature range of -40°C to +85°C (-40°F to +185°F).
ID Whisper Mode: If user keys repeater during CW ID, the ID automatically drops volume by 50%. If user keys repeater during voice ID, the ID changes temporarily to CW at 50 percent volume.
RS-232 setup and parameter configuration.
Password protected DTMF commands for most common control functions.
User-selectable DTMF Mute/Unmute.
Courtesy beep and hang-time can be independently enabled or disabled.
Courtesy beep frequency is user-selectable, providing easy identification of multiple repeaters using the same call-sign.
User-selectable CW tone frequency and word-per-minute rate.
Courtesy beep, CW tone, and voice audio levels all independently adjustable.
User-programmable timers for transmit timeout, repeater identification, and transmit hang time.
Low ( Multi-colored status LEDs for power-on, squelch open, and PTT active.
PTT enable/disable switch.
PTT lock-on switch for transmitter adjustments.
Connector providing basic signal I/O for connection to non-Mastr II transmitters and receivers or test equipment.
The PSE-508-2 is designed specifically to be installed in a GE Mastr II card cage.
Price: $159.50 USD
The PSE-508-3 includes all the features of the PSE-508-2 plus a fully-integrated on-board four-channel CTCSS decoder and encoder suitable for community-tone panel operation.
The PSE-508-3 is designed specifically for installation in a GE Mastr II card cage, making it easy to install and set up.
Same features as PSE-508-2
On-board four-channel CTCSS decoder and encoder (community-tone panel).
DX-Patrol Converter for OSCAR-100 DX-Patrol Uplink Converter for OSCAR-100 (QO100) Geos. Satellite.
434MHz to 2400MHz Low Cost (~100 EUro) Up convertor with 100mW of RF Power to "QO-100" Satellite.
Source (Link) to DX-Patrol Company
DAIWA CN-901-HP-3 SWR Meter CN-901HP with true peak power readout.
All Daiwa SWR meters can be selected to display average or peak power. The PEP value is found by different charge/discharge constants and therefore is not very...
Comment for PSE-508-2/3 full-featured repeater controller for the GE Mastr II series of repeaters