Effective Datatransmission over Shortwaves. PACTOR-II & PACTOR-III, Compact unit, Low power consumption, GPS interface for NMEA data. The Multimode-Controller for PACTOR-III, PACTOR-II, PACTOR-I, AMTOR, NAVTEX, RTTY, CW, FAX, SSTV, AUDIO-Filter, Packet-Radio and PSK31
The PTC-IIIusb allows direct connection to a USB interface of the modern notebook, and thus expands the SCS equipment program. The PTC-IIIusb is constructed using existing equipment technology and its application is to be found mainly in the connection of clients. As a speciality, the PTC-IIIusb is equipped with a transceiver control port, which allows remote control of the connected radio via software.
Fully compatible to existing software by using a virtual COM port assigned by the USB driver.
One single connector to the HF/VHF transceiver for all modes.
Transceiver control for ICOM, YAESU, SGC, KENWOOD and Rohde&Schwarz, including RS232 for modern transceivers.
Supported by Airmail/GetFax.
Special JVCOMM32-Mode for optimum cooperation with JVCOMM32.
Packet-Radio with 300, R600, 1200, 9600 and 19200 baud with built-in DSP.
With two high performance processors from Freescale, the PTC-IIIusb achieves outstanding flexibility.
Sophisticated signal processing and analyzing maintains a stable HF link even during difficult propagation conditions.
Temperature compensated crystal oscillator.
2 MB of static RAM.
Electronic (silicon) serial number.
Noise free HF reception by use of HF suitable construction, 6 layer multilayer board and filtering of all inputs and outputs.
Compact SMD assembly.
Flash-ROM for easy firmware updates.
Dimensions: 125 W x 43 H x 138 D mm, 1.69 H x 4.92 W x 5.43 D inches.
Weight: 450 g
Power Supply: +10 to +20 V DC, 300 mA max. Reverse polarity protected.
Max. 1200 Bit/s, incl. data compression.
Automatic adaption to the channel quality in 4 speed levels.
Bandwidth 500 Hz.
Use of the most modern transfer mode technics: convolutional coding, Viterbi-decoder, soft-decision and Memory ARQ allows error free data transfers even with inaudible signals.
Automatic frequency correction of ± 80 Hz.
Automatic adaption of the radio’s transmit power to the channel quality is possible.
Like PACTOR-II, but:
max. 5200 Bit/s, incl. data compression.
Automatic adaption to the channel quality in 6 speed levels.
Bandwidth 2400 Hz.
Newly developed very robust modulation for HF-Packet-Radio and APRS.
Max. 600 Bit/s.
Automatic frequency correction of ± 250 Hz. APRS
Fully automatic APRS-Beacon
Includes installation manual, CD-ROM, cables and power plug.
*PACTOR-III – pre Installed.
Icom IC-PW2 1kW HF+ 6m Amplifier
On August 31, 2019, Icom Co., Ltd. announced the IC-PW2 - 1kW linear amplifier in the HF + 50MHz band at its booth at Ham Fair 2019. Full power, full duty specification that uses LDMOS for the final...
HF/VHF/UHF SDR ICOM “IC-705” Transceiver A new HF +50/144/430 Mhz transceiver will be shown and announced on "HAM FAIR 2019" on August 31st (Sat) and 1st (Sun) September 2019 in Tokyo. ICOM "IC-705" 10 Watts of power with new SDR technology.
PTRX-7300 Panorama Adaptor for the IC-7300
A panorama adapter for the IC-7300? What's the point, you might ask, the IC-7300 has such a nice spectrum and waterfall display? Right, but unfortunately the IC-7300 has no output for an external display....