– Transmission test (tuning diplexer and filter, testing amplifier and inspecting the directivity of antennas)
– Reflection test (examining quality of antenna system and feeder system, a tracking receiver is used to improve the noise performance)
– Spectrum display and field strength detection (inspecting radio frequency emissions / searching interference sources)
KC901H is designed for debugging RF devices, such as diplexer, filter, amplifier, splitter, combiner, and testing standing wave of antennas and insertion loss of feeders.
To test a transmitter or receiver, add external attenuator to extend input power range
Perform field strength measurement and interference detection in most frequencies.
Detect the fault point of cables / speed factor measurement.
-KC901S provide vector measurement of S11.
-KC901S is much better to be operated.
-The measured data can be saved and transferred via USB on KC901S with its control instruction provided.
-KC901S can support 40Wh battery giving twice the operation time of KC901H.
-KC901S works down to -40℃(depends on the working temperature of the battery.)
-Test frequencies up to 3GHz with 1Hz resolution and stability better than 1ppm.
-Providing vector measurement on S11 with 0.01 phase resolution and 0.01db amplitude resolution.
-With vector measurement capability of S11, it shows the smith chart, RL(Return loss), characters of phase position, and frequency. Also, it can measure match of the antenna feed system with a build-in cable fault locator.
-In S21 scalar measurement, it has the function of single frequency S21 within range of 100dB.*
-With its non-volatile calibration data built-in, on site calibration is not necessary if performing a qualitative measurement. While performing rigorous test, you may use the SOL to enhance the calibration.
-A handy field strengthen meter with a wide dynamic range.
-Built in DDS, audio signal source function.
-Data can be saved in the Memory Card or be transferred into PC via USB.
-3.5 inch color-display
-Excellent response speed with accurate key feeling, less than 3s ready to use.
-Functions are stable and reliable with the excellent hardware/software design.
* in accordance with Technical parameters
Icom IC-PW2 1kW HF+ 6m Amplifier
On August 31, 2019, Icom Co., Ltd. announced the IC-PW2 - 1kW linear amplifier in the HF + 50MHz band at its booth at Ham Fair 2019. Full power, full duty specification that uses LDMOS for the final...
HF/VHF/UHF SDR ICOM “IC-705” Transceiver A new HF +50/144/430 Mhz transceiver will be shown and announced on "HAM FAIR 2019" on August 31st (Sat) and 1st (Sun) September 2019 in Tokyo. ICOM "IC-705" 10 Watts of power with new SDR technology.
PTRX-7300 Panorama Adaptor for the IC-7300
A panorama adapter for the IC-7300? What's the point, you might ask, the IC-7300 has such a nice spectrum and waterfall display? Right, but unfortunately the IC-7300 has no output for an external display....