The new RCU is available as an option for all Acom 2000A amplifiers ever built!
RCU Size: 167 x 130 x 25mm (6-2/3″ x 5-1/8″ x 1″) Only the Remote Control Unit needs to be placed near the operator. The main unit can be installed up to 3 meters (10 feet) away. RCU features include: amplifier status shown on LCD display, control of all functions, measuring and/or monitoring of the 20 most important parameters, on-board technical assistance, troubleshooting suggestions, record of power-on hours, password provided.
NOTE: All ACOM A2000 units come with the RCU unit. This is sold as as separate part or replacement.
• POWER SWITCH -> OFF STATE:
HELP – to read serial numbers, power-on hours, suggestions
• SET/EXIT BUTON -> OFF MENU
CALL SIGN – to change display message while in OFF-state
AUTO ANTENNA CHANGE – to select the logic of the antenna change
AUTO OPERATE – to select the behavior of the amplifier after a “soft” fault
SELF ADDRESS – to select the address of the amplifier if used in a network
CLEAR THE USER TUNINGS – to delete all USR-tunings
CLEAR THE MEMORY – to delete all stored data
• ON/OFF BUTTON -> MAIN MENU -> OPR/STB BUTTON – to activate and use the amplifier.
AUTO TUNE – to match antennas (USR-tunings preparation)
• SET/EXIT BUTTON -> MANUAL MODE –
MANUAL.TUNE – to match loads manually
MEASURE – to measure various amplifier operating parameters
SERVICE – to check motors’ motion and tubes’ zero-signal current
CAT SETTINGS – to tell the amplifier what transceiver is connected to it via CAT
– LOCK – to protect the amplifier from unauthorized users