ANAN-G2-1K 1000W HF & 6M SDR Transceiver

 

SPECIFICATIONS:

1500W (High Power Mode), 800W (low Power Mode)

The G2 (Gen2 SDR) provides the same stellar Receiver and transmitter performance as the earlier ANAN radios, however, it provides a huge leap forward in processing capability and flexibility in use case scenarios.

• Large FPGA with 930 GMAC/s of processing capability
• Built-in Linux OS with Desktop running on a quad core Arm platform
• Capable of Stand-Alone operation without a PC
• Use it with a PC running Thetis
• Hardware capable of remote operation (please note this is a future feature set not currently available)
• Rich I/Os – 2 x HDMI 4K, Gigabit Ethernet, 2 x USB

General Specifications:

• Architecture: Direct Sampling DDC/DUC Transceiver
• Microprocessor controlled protection for SWR, Temperature, Voltage/Current (Over or Under)
• Interface: Ethernet
• Phase Noise (Clock): -149dB @ 10Khz
• TCXO Stability (Typical): /- .1 PPM
• Modes: CW, SSB, NFM, AM, Digital
• Antenna Ports: Three SO-239 50 ohms Software Configurable Ports, One BNC for RX2
• Frequency Resolution: 1 Hz

Electrical Specifications:

• 100-250v AC

Mechanical Specifications:

• 15Kg (approx. Weight)
• 49.7cm L x 38.4cm W x 13.8cm H (not including extrusions)

Receiver Specifications:

• Receiver Architecture: Direct Down Conversion
• Dual 16 bit Phase Synchronous ADCs
• Independent filter banks for each ADC
• 10/6M LNAs
• Frequency Coverage: 9Khz to 60Mhz
• Attenuator: 1-30dB step attenuator
• Reciprocal Mixing Dynamic Range (RMDR): 116dB @ 2Khz
• Receiver Phase noise: -149dB @ 10Khz
• Image rejection: 100dB
• Hardware support for 7 independent receivers assignable to either ADC

Transmitter Specifications:

• Transmitter Architecture: Direct Up Conversion
• DAC Resolution: 16 bit
• RF Output Power (Maximum): 1000W PEP: SSB/CW. 500W:  FM, RTTY, Digital. 275W: AM
• IMD: IMD3 typically -72dB @ 1000W PEP output on 20M
• Harmonics: Typically better than -50dBc on HF and -60dBc on 6M
• Carrier and Opposite Sideband Suppression: Better than -80dBc
• Transverter IF Output: 0db to 15dB

IOs:

• RCA Line In, Digital In, PTT in, PTT Out
• DB9 Seven Software configurable Open Collector Outputs
• SMA XVTR TX Out, 10Mhz Reference Input
• 6.25mm Barrel Mic, CW Key, Headphones and Speaker Outputs
• SMA PureSignal (Predistortion) Loop Input and Output
• RJ45 Ethernet LAN Connector
• 2 x HDMI
• 2 x USB

	ANAN-7000/8000DLE MKII	ANAN-G2
FPGA DSP Peak Processing capacity	240 GMAC/s	930 GMAC/s
Number of DDCs	8	10
Stand-Alone Capability	No	Yes
Thin Client/Remote Capability	No	Hardware Capable (Future Feature Set)
Protocol 2 Support	Beta	Fully Supported
Built-in CPU	No	Yes
Balanced Audio Input

 

Link

Price: $7495.00